DCC Solutions

Full Throttle – Drive Hold

This feature allows you to simulate a loaded or empty train by pressing the F1 function button. When the button is pressed, the motor will remain at a constant speed, while the sound can be controlled independently by adjusting the speed on the throttle. This exciting, new feature gives the operator the ability to have the train crawl in notch 8 or coast at 100 km/h. Release the Drive Hold function button and you simply go back to throttle-controlled speed and motion. Available only from DCC Solutions, our Drive Hold will stop your loco when you reduce the speed to zero even while the function is still active. Your ESU factory fitted or downloadable sound will not stop your loco at speed step 0 with the drive hold on.

Coasting on Demand

This feature allows you to enter coasting mode whenever you want with a press of a button. Often when coming to a stop, the throttle of a real locomotive is put into Idle and the locomotive coasts to a stop. Another situation that occurs is that once a train is up to speed when operating over the

NSW's countryside, the driver can coast to maintain a certain speed. By pressing the coast function button, the sound drops into coasting and remains there. Using the throttle speed control, you can now speed up or slow down the train with the sound remaining in coasting mode.

Press the function button to exit coasting and the sound will exit and return to whatever speed is set when exiting.

Working Brake

Press the Brake Function button and your locomotive will come to a stop at a much shorter distance than if you were to bring it to a stop by reducing the throttle speed. Release the brake and your locomotive will move off again or choose to have it remain stationary when the brake is released.

Working Dynamic Brake

Apply the Dynamic Brakes and the Prime Mover will wind down to idle while the Dynamic Fans engage to assist with cooling. Reduce the throttle and the decoder's dynamic braking logic will reduce your speed faster than normal. Disengage Dynamic Braking and the primer mover will returned to it's notched speed and the fans will turn off.

Random Start-up Sequences with Move Off and Stopping Sounds

Now with random start-up sequences including hot or cold engine starts your start up and shut down will not always sound the same.

As your locomotive begins to move off you will hear the sounds of brakes releasing with random speed activated wheel squeal, rail noises and other sounds. Some of these sounds are random or speed sensitive that will turn on/off automatically depending on your take off speed. When the locomotive comes to a stop you will hear the squeal of the brakes, air releases and then the compressor will cut in automatically to fill the reservoirs with air until full and will cut out.

Coupling and Release with Shunting Mode

Activate coupling or release and your loco will automatically reduce its speed to allow for a more realistic coupling or release operation. Once the operation is completed your loco will continue to run at slow speed for a few more seconds before returning to the speed set on your throttle.